Publicidad
PREP THE WALL
1. Locate the studs and drill four holes using a 3/32" drill bit.
NOTE: If no stud is available, drill a 1/4" hole for each wall anchor and use the supplied wall anchors.*
2. Attach the cleats to the wall using the screws provided, two per cleat.
3. Check the cleats for level and adjust as needed. Tighten the screws in place.
NOTE: When wall anchors are used, keep turning the screw at least four more times as shown.
4X
* Actual wall anchor many differ from type shown.
MIRROR INSTALLATION
1. Align the mirror to the marked centerline, holding the mirror against wall with the mounting slots above the mounted cleats.
2. Lower the mirror onto the cleats until fully engaged. Check for level, adjusting the cleats as needed.
1
2
Cleat
Cleat
Mirror
Mirror
Wall
Wall
© 2022 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
Part no. 209-1440 01/24/2024
5
800.877.2376
www.robern.com
Craft Series Mirror
Publicidad
