LED2WORK INROLED 70 Manual De Instrucciones página 10

5 | Connection
Suitable connection material, cables and accessories can be found in the accessory range of LED2WORK.
The light has to connected via a suitable cable through the end cover with cable gland. The supply cable is connected to
the light via a cable connection and a WAGO terminal.
Connection of the light may only be carried by a qualified electrician!
WAGO connection terminal input:
1. Undo plastic nut of cable connection.
2. After undo the 3 screws of the connection side of light, you can take off the end cover with the cable connection.
3. Insert the connection cable with the open ends.
4. Install cable end according to the dra-wing of this WAGO terminal.
5. After the correct installation, put on the end cover and screw it together again. Pay attention
of a correct seat of the seal and tight the srews handtight only! Do not use an electric
screwdriver!
10 | BA INROLED_70 24V DC . BA 07/2024
Through-wiring (cascadable): Via through-wiring (cascadable) allows the electrical
connection of several lights provided for this purpose.
Cascadable: The total current consumption must not exceed 4 A DC at ta +40°C max.
(104°F max.)
The light is not equipped with a ON/OFF switch. Usually you switch the light ON or OFF
via external switches of machines or systems.