Publicidad
Idiomas disponibles
Idiomas disponibles
SPA COMPONENT
OPERATION
AIR CONTROL VALVE
The air control valve serves to regulate the
amount of air mixed with the water when the
jets are operational. Rotate the air control
in one direction to achieve the maximum jet
pressure and therapeutic action. Rotating the
air control in the opposite direction to turn
air off and allow the jets to work with water
only. Turn the air controls off when the spa
is not in use, this will prevent cold air from
entering the spa and will keep heating cost to
a minimum. The ozone jet (when equipped),
will always produce air bubbles.
DIVERTER VALVE
The diverter valve on your spa allows you
to direct the flow of water from the pump to
one of two combinations of jets. The function
of the diverter valve can best be learned by
experimentation. Turn the large valve all the
way to one side or the other to see which jets
are on.
HYDROTHERAPY JETS
The hydrotherapy jets are recessed in the wall
of the spa. Rotate the jet face one direction or
the other to turn the jets on or off. Not all jets
have a rotational face to turn the jets on or off.
Turning a jet on or off will increase or decrease
the effects of any jets "not" in the closed posi-
tion.
OZONE GENERATOR
(WHEN EQUIPPED)
The ozone system greatly enhances the
quality of the spa water when used to
supplement the spa owner's regular water
maintenance program. Contrary to some
information circulated throughout the pool
and spa industry regarding ozone systems,
ozone CAN'T be used as a single-source
COMPONENT OPERATION
(WHEN EQUIPPED)
sanitizer, water clarifier, anti-foamer, and
mineral chelating agent. A secondary source
sanitizer must be used to maintain 2.0 ppm
(2.0 mg/L) of Free Available Chlorine (FAC).
LIFESMART recommends that a chemical
maintenance program based on recognized
and documented industry standards still be
followed when using an ozone purification
system to assure water sanitation and the
highest quality purified water.
WATERFALL
If your spa has a waterfall, there will also be
a control valve to operate the amount of flow
through the waterfall from no flow to a steady
stream. This valve will be located in various
positions on the spa depending on the model
and some models have the valve attached to
the waterfall.
Note: The air control valve and the waterfall
flow valve may look exactly the same,
however; they are separate components.
15
(WHEN EQUIPPED)
Publicidad
