Publicidad
Idiomas disponibles
Idiomas disponibles
SURFACE CARE
Do not use solvents or abrasive cleaners to
clean the spa. Typically, a mild detergent and
water will resolve cleaning issues.
NOTE: Rotomolded spas are made from a thick,
durable plastic that may bend or flex slightly over
time. This slight fluctuation is purely cosmitic and
does not impact the structure integrity or fuction of
the spa.
COVER CARE
The cover is made with a solution dyed
polyester fabric and is an attractive, durable
foam insulation product. Monthly cleaning is
recommended to maintain its beauty and a
longer fabric life.
To clean and condition the polyester cover:
1. Remove and gently lean against a wall or
fence. If a cover lifter has been installed
keep cover closed and make sure all
seams are closed to prevent any soap
from entering the spa.
2. With a garden hose, spray the covers to
loosen and rinse away dirt or debris.
3. Add four tablespoons of mild soap or mild
dishwashing liquid with one gallons
(4 liters) of lukewarm water. Clean using
a soft bristle brush. Rinse thoroughly with
cold water and air dry.
IMPORTANT: Do not let the polyester
dry with a soap film on it before it can be
rinsed clean.
4. Scrub the cover's perimeter and side
flaps. Rinse clean with cold water.
CABINET CARE
Little maintenance is required to keep your
spa cabinet looking good.
Spa cabinet product should be cleaned as
needed to remove dirt and debris.
•
NO abrasive or harsh chemicals should
be used on your spa's cabinet.
•
NO solvents or cleaners containing
aromatic solvents should be used on your
spas cabinet.
SPA MAINTENANCE
19
•
Hot soapy water is the best choice for
cleaning your spa's cabinet.
AVOID PROLONGED EXPOSURE TO
DIRECT SUNLIGHT OR EXCESSIVE TEM-
PERATURES
100ºF (38ºC) to avoid your spa cabinet from
buckling.
SPA LED LIGHT
REPLACEMENT
•
Turn OFF the power to the spa.
•
Remove the equipment compartment ac-
cess door.
•
Locate the rear of the spa light.
•
To remove the LED, turn outside housing
counter clockwise ¼ turn, and pull out and
remove LED from socket.
•
Replace the LED by reversing the above
steps.
Publicidad
