Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE:
It is normal for high capacitance measurement when it takes a
few seconds for the reading to stabilize.
5.4. Measure AC or DC current
Do not try to measure current on the circuit, when the
voltage between the open circuit voltage and the ground
exceeds 250V. If the fuse is blown during measurement, you
may damage the meter or hurt yourself.
In order to avoid damage to the meter or the equipment under
test, please check the fuse of the meter before measuring
current. When measuring, use the correct input terminal,
rotary switch and range. Do not connect the other end of the
test lead to any circuit in parallel. When the test lead is
plugged into the current input terminal.
Use the "FUNC." to switch between DC and AC measure-
ment modes.
1. Turn off power to the circuit. Turn the rotary switch to a
suitable current gear.
2. Connect the black test lead to the "COM" terminal and the
red test lead to the corresponding current input terminal.
3. Connect the test leads in series to the circuit.
5. Turn on power to the circuit. Read the measured current on
the display. If the LCD display "
range.
", please select a higher
36
Publicidad
