Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE:
(1) The connection time should not exceed 10 seconds when
measuring 5-10A high current, the test data will not be
stable due to heating.
(2) The measurement interval takes 3-5 minutes when multiple
measurements are made
5.5. Test diodes
In order to avoid damage to the meter or the equipment
under test, before the diode measurement, the power supply
of the circuit under test should be cut off and all high-voltage
capacitors should be fully discharged.
1. Turn the rotary switch to the "
to switch to the "
2. Connect the black test lead to the "COM" terminal and red
test lead to the "
3. Connect the black test lead to the cathode and the red test
lead anode of the tested diode.
4. The meter will display the forward bias value of the diode
under test. If the polarity of the test lead is reversed, the
meter will display " ".
", and push "FUNC".
".
" terminal.
37
Publicidad
