Yeyian AVANCE Serie Manual Del Usuario página 6

STAND INSTALLATION
Steps:
01. Put the base into the hole of the rear shell at a tilt along the arrow direction, as
shown in Figure 1.
02. Insert the base into the support and lock two M4*16 screws, as shown in Figure
2.
03. Rotate the whole base clockwise downward and put it in, as shown in Figure 2
and 3.
To remove the entire base, perform the following steps.
01. Unscrew the two M4*16 screws on the base and pull it out in the arrow direction,
as show in Figure 4.
02. Push the slider near the VESA cover of the base upward, as shown in Figure 5.
03. Rotate the whole base counterclockwise upward, as shown in Figure 5.
04. Tilt the base along the arrow direction and take it out, as shown in Figure 6.
Note:
Some of the contents in this manual may differs lightly from the final product, and
the later shall be referred to.