Publicidad
Idiomas disponibles
Idiomas disponibles
Never position the Mobile Handheld Computer with battery in close
proximity to heat sources (heating fans or similar equipment) and
never expose it to direct sunlight, excessive dust sources or
shocks.
ATTENTION
In order to prevent excessive heat, the Mobile Handheld Computer,
battery, as well as the docking station and the power pack must
not be covered while in use.
ATTENTION
Make sure there is no risk of stumbling over connection cables or
power packs.
ATTENTION
3.2.1 Charging the Power Supply Unit for the DS260 & M260TE
The M260TE and the spare battery may only be charged in the DS260 docking station with the respective
power supply unit.
External power supply unit for DS260
Input voltage
Output voltage
Power supply must be a SELV/LPS approved component.
Power cable (country-specific)
Unintended use of the interfaces should be avoided.
ATTENTION
3.2.2 Changing the battery
The battery compartment is located at the rear end of the Mobile Handheld Computer. In order to open the
cover, first remove the transverse hand strap by unhooking it. Now push the locking tab on the battery
compartment cover towards the cover surface. The compartment then opens.
The battery can be inserted without the use of force. The long groove on the unlabelled side of the
battery is the top side. The opening of the groove faces the recess for the opening mechanism. In doing so,
ensure that you insert the battery at a slight incline towards the contacts and then bring it into its final
position while applying a slight amount of pressure. You can see how to insert the battery in Fehler!
Verweisquelle konnte nicht gefunden werden.. First, place the cover on the three securing straps and
then push into the locking mechanism.
Figure 3: Changing the battery
M260TE_Brief Overview_Resumen breve_FCC_V1.11_en_es
~
100 – 240 V AC; 1.0 A; 50 – 60 Hz
15 V DC; 2.4 A
8 / 35
Publicidad
