Publicidad
3.
Drill pilot holes using a 7/32 in. (5.5 mm) diameter drill bit. Remove wall plate template
IMPORTANT: Be sure to drill into the center of the stud.
IMPORTANT: Pilot holes must be drilled to a depth of 3 in. (75 mm).
4.
Install wall plate
using two lag bolts
07
CAUTION:
Avoid potential personal injury or property damage! Both lag bolts
plate
. Ensure the wall plate is securely fastened to the wall before continuing on to the next step.
07
3
06
08
and two washers
09
. Tighten the lag bolts only until they are pulled firmly against the wall plate.
3 in.
(75 mm)
7/32 in.
(5.5 mm)
.
06
08
MUST BE firmly tightened to prevent unwanted movement of the wall
4
07
08
09
9
Publicidad
