Publicidad
Idiomas disponibles
Idiomas disponibles
7. TROUBLESHOOTING
Symptom
Tool does not operate properly:
LED light flashing 2 times
LED light flashing 3 times
Tool operates properly, but
fasteners do not drive fully.
Tool operates properly, but
fasteners are driven too deep.
Frequent dry fire
Tool jams frequently.
12
12
20V Cordless 16 Gauge Finish Nailer
Possible Causes
Battery is low.
Tool is hot.
Depth of drive isn't deep enough.
Nail is too long for wood hardness.
Depth of drive is too deep.
Jammed nails or damaged nails.
Incorrect nails
Damaged nails
Dirty magazine
Possible Solution
Charge the battery pack.
Wait until the tool cools down.
Adjust depth of drive.
Use nail length that is appropriate for
wood.
Adjust depth of drive.
Pull up on the tool free jam release
and unhook the latch. Check whether
there are jammed nails or damaged
nails inside. If so, remove the jammed
nails or damaged nails in time.
Verify that nails are the correct size.
Replace nails.
Clean magazine.
Positec USA, Inc. Charlotte, NC 28216 USA
EN
Publicidad
