Gas Connection; Electrical Connection; Electrical Shock Hazard - Whirlpool AKR 313 Manual De Instrucciones

2.3 Gas connection

Fire hazard
Always use certified hoses and
pressure regulators.
Check expiration date of hoses, hose
and pressure regulators and replace
them if necessary.
Properly secure and tighten all gas
connections during installation.
Install the appliance according to the
instructions described in this manual.
Failure to do so can result in
explosion, fire or death.
Important:
This operation must be carried out by a
qualified professional.
• The gas supply system must comply with
local regulations.
• The connection of the cooktop to the gas
pipe network or gas cylinder must be
made by means of a rigid copper or steel
pipe with fittings complying with local
safety regulations, or by means of a
continuous-surface stainless steel hose
complying with local regulations.
Interpose gasket (B) in the elbow
connection (A). The maximum length of
the hose is 2 m.
Important:
If a flexible stainless steel tube or flexible
hose is used, it must be installed so as
not to touch any mobile part of the
furniture. It must pass through an area
where there are no obstructions and
where it is possible to inspect it on all its
length.
Manual W10777749.indd 42 Manual W10777749.indd 42
• After connection to the gas supply, check
for leaks with soapy water. Light up the
burners and turn the knobs from max
position to minimum position
flame stability.
A

2.4 Electrical Connection

Electrical Shock Hazard

Disconnect the electrical supply
before servicing or cleaning the
cooktop.
Replace all components before the
cooktop on.
Do not remove grounding wire.
Connect grounding wire to an
effective ground.
Do not use an adapter or T.
Do not use an extension cord.
Failure to follow these instructions
can result in fire, electrical shock or
death.
42
to check
B
14/07/15 10:25 14/07/15 10:25