HyperMotion CLIMBER 6FT Manual De Instrucciones página 22

21
Step 3:
Repeat step 2 until the bottom circle is formed as shown in the picture.
Step 4:
Take 3 tubes (part B).
Connect them with one bolt (part E), one nut (part K), and one washer (part H).
The order of connecting the pipes must be as shown in the figure.
First, put the washer on the bolt. Then insert the bolt from the inside through Tube # 1, Tube #
2, Tube # 3, Tube # 4 and Tube # 5, and hand tighten the nut on the bolt.
Make sure the tubing is always in a counterclockwise direction.