Publicidad
Idiomas disponibles
Idiomas disponibles
FUNCTIONAL DESCRIPTION
1. Trigger
2. Variable speed lock-on
3. Handle
4. Air intake vent
5. Tube latch
6. Tube
6
5
ASSEMBLY
WARNING
the battery. For specific charging instructions,
read the operator's manual supplied with your
charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
pack any time the tool is not in use.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
mended for this tool. Others may be hazardous.
Tube Assembly
WARNING
blower without tube securely in place. Never
reach into blower through tube hole.
To install:
1. WARNING! Remove battery to
avoid starting the tool.
2. Line up the tab on the tube with
the notch in the housing.
3. Slide the tube into the housing
until it snaps in place.
4. Pull on the tube to ensure it is
secure.
To remove the tube for storage:
1. WARNING! Remove battery to
avoid starting the tool.
2. Press the tube latch and pull the
tube out of the housing.
3. Always reinstall the tube before use.
Installing/Removing the Accessories
To install the nozzles:
WARNING! Remove battery to avoid starting the tool.
Line up the tabs on the nozzle with the notches on
the tube. Slide the nozzle onto the tube until it snaps
in place. Pull on the nozzle to ensure it is secure. To
remove, press the tabs in and pull away from the tool.
1
2
3
Recharge only with the
charger specified for
Always lock the trigger
or remove the battery
Only use accessories
specifically recom-
To reduce the risk of
injury, do not operate
WARNING
safety goggles or glasses with side shields.
Do not point tool at self or bystanders. Keep
bystanders 50' away during use. Objects may be
thrown or ricochet in all directions.
Inspect the area before using the blower. Remove
all debris and hard objects such as rocks, glass,
wire, etc. that can ricochet, be thrown, or otherwise
cause injury or damage during operation.
Starting, Stopping and Controlling Speed
The tool can be controlled two ways - by the trigger
4
or by the variable speed lock-on.
To start the tool, grasp the handle firmly
and pull the trigger or push the sliding
lever forward.
To vary the speed, increase or decrease
the pressure on the trigger or move the
sliding lever forward or back. The further
the trigger is pulled or the sliding lever is
pushed, the greater the air flow.
To lock the tool, use the variable speed
lock-on sliding lever.
To stop the tool, release the trigger or
pull back the sliding lever completely.
Using the Blower
Hold the tube 5"-6" above the ground.
Slowly sweep the blower from side to side.
Move forward slowly, working the debris into a pile.
4
OPERATION
To reduce the risk of
injury, always wear
On
Off
Publicidad
