Polymaker PolyDryer Manual Del Usuario página 3

Read Before Use
•Read these instructions before using this product.
•If you buy a PolyDryer™ Box without the Dry Dock, please refer to the relevant information in this
manual.
•When unattended, please turn o the power supply to prevent accidental fire.
•Remove the power cord from the socket when the product is not in use.
•DO NOT put anything into the heating vent to avoid electric shock.
•DO NOT touch the heating vent when in operation to avoid a burn.
•Pay attention to electrical safety during operation, otherwise, electrical shock, fire, or damage may
occur. Do not use this product near water, such as in bathrooms, near water heaters, or in highly
humid locations.
•Keep the filament tightly wound to the spool or feed the tip of the filament through the outlet while
drying to prevent the loose end blocking the heating vent. Risk of fire or damage.
•Only use the original power adapter.
•DO NOT disassemble or repair it without guidance.
•Always operate on a level surface.
•This user guide is provided for the convenience of users. Diagrams and descriptions may vary
slightly from the actual product. The contents of this user guide can be changed without notice.
•If there is a fault with the product, disconnect the power adapter from the filament dryer and the
electrical socket then contact the after-sales support team.
•Remove the desiccant box from the PolyDryer™ Box when filling or changing the desiccant.
•DO NOT place loose desiccant at the bottom of the PolyDryer™ Box.
•DO NOT operate if any debris (including desiccant) is dropped in the Dry Dock.
•DO NOT leave the dryer unattended when switched to Continuous Mode.
PolyDryer™ Specification
Product Description
Product Size
Power Adapter Specification
Maximum Working Power
Working Environment
Maximun Capacity
Conduct Filament Diameter
Supported Material
PolyDryer™ Box Specification
Product Description
Product Size
Maximun Capacity
Conduct Filament Diameter
3D Printing Filament Dryer
235(L) x 120(W) x 290(H) mm
Input: AC 100~240V, 50/60Hz
Output: DC 24V, 68W
68W
Environment temperature: 20°C ~ 35°C
Relative humidity: below 90%
205 Ø *78(H) mm (Filament with spool)
1.75 / 2.85 / 3.00 mm
PLA / PVB / PETG / ABS / ASA / TPU / PA / PC / PVA /
PolySupport™ / PolySupport™ for PA12
3D Printing Filament Storage Box
235(L) x 120(W) x 235(H) mm
205 Ø *78(H) mm (Filament with spool)
1.75 / 2.85 / 3.00 mm
EN
1