Polymaker PolyDryer Manual Del Usuario página 9

Note
•When you notice that the hygrometer display has faded, please replace the battery with 1.5V LR44.
•When the screen shows E001/E002/E003/E004, please turn o the machine and contact
suppor@polymaker.cm to report the issue.
•In Continuous Mode, the drying time is unlimited until the user stops the drying process.
•Use spool roller to internally mount the spool, when the edge of spool damaged.
•To enhance printing quality, please dry the filament completely in reference to the settings in
Recommended Power level.
• When you notice the most of desiccant has changed color from blue to light pink, then the
desiccant has absorbed enough moisture and must be dried. The recommended procedure is as
follows:
1. Place the PolyDryer™ Box without the filament on the Dry Dock, use power level 3 and dry for
~8 hours until the desiccant turns blue. The desiccant should be placed in the same orientation
as the screen on the Dry Dock , which facilitates the hot air blowing onto the desiccant and
improves drying e ciency.
2. Remove the silica gel desiccant from the PolyDryer™ Box (without including any other parts)
and place it in a heat-resistant container. Use an oven to heat at 110-130°C for 1-2 hours until
the desiccant turns blue.
3. Remove the silica gel desiccant from the PolyDryer™ Box (without including any other parts)
and place it in a heat-resistant container. Use a microwave, select a low power level, heat for
30 seconds, then flip the desiccant, and heat for another 30 seconds until the desiccant turns
blue.
EN
7