PNI House WIFI800 Manual De Usuario página 6

First usage
1. Install a micro SD card or a 2.5 inch hard disk in the NVR.
2. Connect the mouse included in the package to the USB port.
3. Connect a monitor to the HD-out port using an HDMI cable.
4. Connect the NVR to the router with an Ethernet cable. Note: The NVR
is connected to the router only by cable.
5. Power the NVR to a 230V power source using the power adapter (230V
- 12V 2A) included in the package. After a few seconds, the voice prompt
will confirm turning on the device.
Turn the NVR off
There are two methods of turning off the device.
1. Access the main menu (right click on the screen) and select the Logout -
Shutdown option
2. Turn off the power supply.
Configuration
Note 1: Configure the system (NVR + cameras) before installing the devices
in the final location.
Note 2: The voice prompt will accompany you throughout the configuration.
1. After starting the NVR, the quick configuration interface (Startup wizard)
will be displayed on the monitor. Follow the steps on the screen.
2. The system will detect that no camera is connected to the NVR and will
start the quick pairing procedure (Quick pair). Note: You can cancel the
pairing of the cameras at this step and resume it after completing the
configuration of the network parameters (see step 6).
3. Set the time zone, date, time and language.
4. Set the user and access password. Follow the steps on the screen.
5. The system will check the network parameters. If all parameters have OK
status, proceed to the next step by pressing the "Next" button. If the
network parameters are not OK and you want to configure them manually,
press the "Network" button. Check the DHCP option for the automatic
English 6 User manual