PNI House WIFI800 Manual De Usuario página 7

retrieval of the parameters or manually enter the requested information
(IP Address, Gateway, Subnet mask, etc.)
6. After correctly configuring the network parameters, you will be redirected
to the IP channels configuration interface.
7. The system will automatically scan (or you can press the "Search" button)
the cameras in the network (in the case of cameras already configured in
the same network as the NVR) or new unconfigured cameras (the camera
needs to be restarted to be identified by the NVR).
8. After identifying the cameras, press the "Add" button to add each camera
on one channel.
9. After successfully adding the cameras, press the "Next" button.
10. In the following interface, you can download the mobile application (ICSee)
by scanning the QR code on the screen.
11. Set the channel display parameters on the screen: channel name, time
display, recording status display, alarm status, monitor resolution* etc.
* Maximum supported resolution 1920x1080px.
Note: Before changing the resolution, make sure that the monitor connected
to the NVR supports that resolution. If the resolution set in the menu is higher
than the resolution of the monitor, nothing will appear on the monitor and you
will no longer be able to access the menu. If, however, this happens, connect
the NVR to a monitor with a higher resolution, access the menu and change
the resolution.
12. Click OK to complete the NVR quick setup procedure
The Menu
In the main preview interface, right-
click with the mouse to access the
menu.
User manual 7 English