Sharp Aquos AN-65AG1 Manual De Manejo página 25

Installing the Liquid Crystal Television on the wall
• Be sure to use at least 4 people when installing the Liquid Crystal Television to the base bracket.
Caution
• Be sure to perform Steps 1 and 2 below. Only performing Step 1 could result in the display falling and
injuring someone.
■
The LC-65GE1 (Separate type) is used as an example for the following explanation. The procedure is the same
for the LC-65D90U (Integrated type).
Install the wall-mount bracket attached to the Liquid Crystal Television to the base bracket.
1
Hang the square holes of the wall-mount bracket on the hooks (see page 4) of the base
bracket unit.
Check to make sure the hooks are securely inserted into the notches at the top of the slanted
side of the wall-mount bracket unit.
Fasten the screws in the wall-mount bracket
2
unit and bottom of the base bracket (Be sure
to do this).
Fasten using the included wall-mount bracket
fastening screws (M6 length: 8 mm × 2 screws).
Notch
Included part
Wall-mount bracket fastening screws
M6 length: 8mm (2 screws)
Hook
Wall
E-11