Ruroc EOX Manual De Instrucciones página 7

PINLOCK
Our EOX helmets are compatible with both anti-
fogging technology and protectint transitional
insert. Please note this item will need to be
bought separately. Visit our
installation information.
Shop PINLOCK
YOUR EOX VISOR
To open the visor, simply place your
thumb under the
gently pull the visor outwards. Expect
some resistance. This is normal. You will
hear and feel the visor click through four
positions until it is fully open. When in use,
please avoid covering the visor and only
make adjustments when it is safe to do so.
WARNING: Do not use tinted visors at night.
For day / track use only.
To remove the visor, lift the visor into the fully
open position, to reveal the visor release tab. You
will know when the visor is in the fully open position
when this pin is right at the top. Push and hold down
this tab and at the same time, pull the visor forward
and away from the helmet to release it. Repeat this
action on the other side of the helmet to fully remove
the visor. Visit our
information.Always ensure your visor is clean before a
journey. It is best to use a microfiber cloth with lukewarm
water. If your visor is scratched or damaged it should be
replaced as soon as possible.
Shop EOX Visors
VISOR
RELEASE TAB
EOX
M005-MAN-001
AT4_MAN_01-00
'how to' guides
thumb tab and
'how to' guides for installation
for
PIN
VISOR ADAPTIVE
CONTROL
To adapt how tight the visor sits
against the seal, simply adjust the two
screws on the visor mechanism.
Visit our 'how to' guides
information.
07
THUMB TAB
for more
WWW.RUROC.COM