Auriol 384285 2107 Guía Rápida página 10

Do not use the binoculars in heavy rain. Other-
wise the binoculars could be damaged.
Preparing for use
Focusing
Q
Close your right eye.
Adjust the view by turning the central focusing
wheel so that the view for the left eye is
3
sharp and clear.
Dioptre vision adjuster
Q
Open your right eye and close your left eye.
Turn the dioptre vision adjuster
is sharp and clear. Retain this position for later use.
+ Focus on a closer object
— Focus on a more distant object
0 No adjustment
Adjustment for eye positions
Q
Hold your binoculars with both hands and
move the binocular body
the two circles are superimposed to form one
full circle (see Fig. C).
Fold down the eyecups
glasses.
After use: Before stowing away the product,
fold up the eyecups.
Adjusting the neck cord
Q
Thread the ends of the neck cord
the buckles (see Fig. D).
6
Thread the ends of the neck cord
the cord guides [13] (see Fig. E).
Then thread the ends of the neck cord
through the buckles
10 GB/IE
until the object
2
(see Fig. B) until
4
if you wear eye-
1
through
7
through
7
7
(see Fig. F+G).
6
Pull the neck cord
buckle . This fixes the neck cord
6
buckles (see Fig. G).
6
Use with a tripod
Q
Note: The tripod and the tripod adapter are
not included with the product. They can be pur-
chased separately from your specialist dealer.
Observe the operating instructions supplied
with your tripod during its assembly and use.
Connecting the tripod adapter: Unscrew the
protective cap from the threaded tripod mount
socket . Do not misplace the protective cap,
5
keep it at a safe place.
Screw the threaded connector of the tripod
adapter clockwise into the threaded tripod
mount socket on the binoculars. Then con-
5
nect the tripod to the attached tripod adapter.
After use, separate the tripod from the tripod
adapter. Then unscrew the threaded connector
of the tripod adapter anticlockwise out of the
threaded tripod mount socket
ulars. Before stowing away the product, screw
the protective cap again onto the threaded tri-
pod mount socket
Note: Turn anti-clockwise to unscrew
the protective cap for tripod adapter.
Cleaning and care
Never take your binoculars apart for cleaning.
Clean the binocular lenses with the provided
cleaning cloth or use a soft threadless
9
cloth.
Do not press hard when cleaning the delicate
lens surface.
If the lenses are still dirty, dampen the cloth
with a little clear alcohol (methylated spirit).
During periods of non-use: Always cover the
eyecups and the lenses by the eyecups
1
cover and the lens cover
11
This helps to avoid scratches on the lenses.
Clean the binocular body
cloth.
tight on both sides of the
7
on the
7
on the binoc-
5
.
5
respectively.
10
with a dry, lint-free
4