Publicidad
Idiomas disponibles
Idiomas disponibles
REMOTE CONTROL FUNCTION
MUTE
MODE
10
MENU
VOL+
ENT
11
VOL-
12
1
2
3
4
5
6
7
8
9
0
NOTE:
1. Before using the remote control, please remove the battery insulation paper at
the bottom of the remote control.
2. If the remote control does not work, please take the battery off and wipe it,
then put it back, generally it can be used normally. Still not working, it may be
that the remote control battery is low, please replace the remote control
battery.
ENGLISH
1
1. Mute On/off
2. Mode: Switch For RADIO- USB- BT-
2
AV IN
3. Power On/off
3
4. Volume +
4
5. Enter; Play / Pause
5
6
6. Next Track
7. Volume -
7
8. End Call
8
9. Number Button
10. Menu
11. Previous Track
12. Answer Call
9
7
COMMON PROBLEMS AND SIMPLE TROUBLESHOOTING
1) Unable to boot normally
1. "Yellow" "Red" "Black" this 3 lines only connected 2 line of them, so it will not start, it
should be that the yellow line is connected to the positive pole, red line to the key
control line, black to the negative pole, less connection or wrong connection does not
boot.
2. The original car line and unit wiring can not be connected to the color, the color of the
original car line is not standard, if you connect like that it can not only be turned on but
also may burn.
3. The original car plug can't be plugged directly into the new unit, even if it just plugs in, it
can't be used, otherwise it won't be turned on or burned.
4. The 3 wires are connected right, but it does not boot. Check if the fuse on the yellow line
is broken. If there is no problem with the fuse, twist the yellow and red wires together.
Turn on the key and press the unit's power button to see if it can be turned on.
5. Every time you change the fuse, it burns. Please don't change it again The reason is that
when you first connect the positive and negative poles, the protection circuit of the unit
is short-circuited. The unit can be repaired under the guidance of our master. No basis
can only be returned to the after-sales or new unit. If these are no problem, or also
don't boot, please make the final step to confirm, find a 12V battery or 12V power
supply "yellow" and "red" twist together with the positive, black to the negative pole,
press the button check if it can boot or no, if you can boot, it showed that the original
car line is not right connect, or there is a problem with the car line. If it can't be boot,
the unit is broken. Does not boot unit, check the line carefully, do not blindly suspect the
unit problem.
2) Automatic shut-down
1. The cable error connect: If the blue cable (automatic antenna power supply) is
connected to the power cable of the unit, an automatic shutdown will occur. Please
follow the correct wiring method to solve the problem.
2. The voltage is unstable: please find a 12V-5A which one is the power supply and re-
tested to see if it will automatically shut down. If it does not automatically shut down
after the test, please replace the power supply. If it will automatically shut down, it is
problem with the unit.
3) Having noise
1. The original speaker power is too small. When the volume of the unit is turned up, there
will be noise.
Solution: When replacing the speaker or listening to the song, the volume should not be too
large.
2. The speaker cable is grounded.
Solution: Take the iron speaker cable. Directly connected to the speaker cable of the unit.
8
ENGLISH
Publicidad
