Publicidad
Idiomas disponibles
Idiomas disponibles
FUNCTIONING
1. Place the fan on a flat, dry surface.
2. Plug the fan into a suitable outlet. Select the desired speed setting by turning
the speed control knob.
There are 4 settings:
0 – OFF
1 – LOW
2 MEDIUM
3 – HIGH
3. Use the height adjustment knob to raise or lower the fan as desired
4. The fan can be set to oscillate by pressing down on the oscillation knob on
the motor body. To stop the swing function, pull up on the Nando.
5. To adjust the tilt angle of the fan head, loosen the tilt adjustment knob, rotate
the fan to the desired angle, and then retighten the knob. CAUTION, always
turn off the fan when adjusting
6. Turn the speed control knob to "0" and unplug the fan after use.
5-Device care
1. Always unplug the fan from the electrical outlet before cleaning.
2. Avoid contact with moving parts of the fan
3. Use only a soft, damp cloth to clean the fan
4. Do not immerse the fan in water and never allow water to drip into the motor
body
5. Never spray the device with liquids
6. Do not use gasoline, paint thinner, or other chemicals to clean the fan.
7. Before removing the grille, make sure the fan is unplugged
8. Clean the fan blade and grills with a soft, damp cloth.
CAUTION: The fan blade may have sharp edges. Handle with extreme
care
9. Store the fan in its original box or cover the fan to protect it from dust in a dry
place if it is not to be used for a long time.
6-Specifications
Supply voltage 220-240V 50Hz
Power: 60W
Ø: 40cm
3 speeds
Oscillating: 100º
Sound level: 60.87dB
2
m
:20
7-Environmental protection, device disposal.
- Environmental Protection
The packaging and the appliance are made of materials that can be reused,
whenever possible, dispose of them in a container intended for recyclable
materials.
- Disposal of the device
10
Publicidad
