Kelvinator Commercial KCHGM12R Manual De Servicio página 5

DOORS/HINGES
Over time and with heavy use, door hinges may become loose. If the door is
beginning to sag, tighten the screws that mount the hinge brackets to the frame
of the unit. If the doors are loose or sagging this can cause the hinge to pull out
of the frame which may damage to both the doors and the door hinges.
DRAIN MAINTENANCE
Each unit has a drain located inside the unit which removes the condensation
from the evaporator coil and evaporates it into an external condensate evaporator
pan. Each drain can become loose or disconnected from moving or bumping the
drain. If you notice excessive water accumulation on the inside of the unit, be
sure the drain tube is connected from the evaporator housing to the condensate
evaporator drain pan. If water starts to collect underneath the unit, you may want
to check the condensate evaporator drain tube to be sure it is still located inside
the drain pan. The leveling of the unit is important as the units are designed to
drain properly when on a level surface. If your floor is not level this can also
cause drain problems. Be sure all drain lines are free of obstructions because
this may cause water to back up and overflow the drain pans.
SWING DOOR REPLACEMENT AND ADJUSTMENT
1. Open the bottom panel and hold the door. Then loosen the bottom hinge
screw and take off the old door.
2. Prepare new door; insert top pin into top hinge, get one bottom hinge to hold
the door with the bottom pin. Fasten bottom hinge securely to the door frame
with three screws.
3. Allow the door to freely swing, making sure it swings closed by itself with no
restriction.
4. Plug the unit in and make sure the lock works well.
5. If not, adjust the door height by adding the plastic spacer/washer provided
with the bottom hinge pin.
SLIDING DOOR REPLACEMENT AND ADJUSTMENT
1. Take off the hook of the counterweight of door from the top of the door.
2. Hold the door up until the bottom edge is over the channel. Move the door
out across the channel and lay the door down.
3. Prepare new door; hold the door insert into top channel until the bottom
edge is over the bottom channel. Slide the bottom of the door across the
channel wall and place it into the channel.
REMOVE THE BOTTOM PANEL
Loosen and remove the top screws, slide the panel up and out
LIGHT BULB REPLACEMENT
1. Upper light bulb replacement: Loosen the screws in the bottom of the top
panel and swing the panel up until the light bulb is exposed. Light bulb can
then be changed.
2. LED light bulb replacement: Take the cover off to replace the LED light bulb.
5 GLASS DOOR MERCHANDISER