Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
This guide is intended to acquaint you with the safe operation and
maintenance procedures for the Armada Technologies® Models
Pro50™ and Pro50K™ digital AC/DC Solenoid Activator/Multimeter
and kit. Read the entire guide before operating the Pro50™ or
Pro210F™ filter tone probe found in the kit. Keep this guide
available to anyone who may be required to use these products.
DESCRIPTION
The Pro50K™ consists of a Pro50™ tester, a Pro210F™ advanced
tone probe, and a soft carrying case. The functions of the Pro50™
include:
•
Testing 24V output from the clock/controller.
•
Activating any AC or DC low voltage solenoid.
•
Chattering any AC or DC low voltage solenoid for lost valve
locating.
•
Powering two-wire irrigation control cables to allow fault finding.
•
Sending beeping tone to identify wires.
•
Measuring AC or DC voltage and resistance.
The Pro210F™ Filter Tone Probe is an advanced inductive probe
for identifying wire termination points in conjunction with the
Pro50™ transmitting in tone mode.
Safety
WARNING: To ensure safe operation and service of the Pro50™,
follow these instructions. Failure to observe warnings can result in
severe injury or death.
• The Pro50™ is designed for use on low voltage circuits only.
• Connection to AC power line voltages could damage the Pro50™.
• Use the Pro50™ only as specified in the user guide.
• Use caution around voltages above 30 VAC rms, or 60 VDC.
These voltages pose a shock hazard to the user.
2
Publicidad
