Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY PRECAUTIONS
Fuse amplifiers power wire at the battery.
Be sure to fuse the power wire within 12V of the cars battery. This will protect the cars battery
in case of a short circuit between the HBD-10V and battery. This is a must.
The built-in fuse will only protect the HBD-10V not the car's Battery
Use high grade wire connectors.
To ensure maximum power transfer and secure safe connections, it is recommended to use
nigh grade terminal rings (for connection at battery).
DO NOT RUN any wires underneath vehicle.
Exposed wires have a chance of being cut or damaged. it is best to run all wires through the
vehicle under the carpet and or side panels. This leads to a cleaner installation and less risk
of damage.
Use caution when mounting.
Remember there are many electrical wires. gas lines, vacuum lines, brake lines as well as a
gas tanking the automobile. Make sure you know where they are when mounting the amplifier
to avoid puncturing lines, shorting wires or drilling holes into the gas tank.
Run signal wires away from electrical wires.
To avoid possibility of induced noise from the car's electrical system (i.e., popping noises or
engine noise), run wires away from the cars electrical wiring.
Make all ground wires as short as possible and at the sane point.
In order to reduce the chance of ground loops (i.e., engine noise), make the grounding wire
as short as possible to reduce the wire's resistance. Also, when using multiple components,
make sure all units are grounded at the same point.
Avoid sharp edges when running the wires.
To avoid the possibility of power or signal shorts, be careful not to allow the power or signal
wires to come in contact with sharp edges. Use a grommet to protect the wire when running
through the fire wall.
SPECIFICATIONS
Max Level Input ------------------------------------------------------------------------------6 Volts
Max Level Output --------------------------------------------------------------------------10 Volts
Frequency Response ----------------------------------------------------------------10Hz-20KHz
Total Harmonic Distortion ------------------------------------------------------------------0.016%
Signal To Noise Ratio --------------------------------------------------------------------------->90
Input Impedance------------------------------------------------------------------------>10K Ohm
Output Impedance ------------------------------------------------------------------------150 Ohm
Current Draw --------------------------------------------------------------------------------0.2 Amp
Bandwidth-----------------------------------------------------------------------------25Hz- 200Hz
Center Frequency ---------------------------------------------------------------------25Hz - 65Hz
Due to continuous improvement of the product, specifications are subject to change without notice.
02
2
Publicidad
