Publicidad
Idiomas disponibles
Idiomas disponibles
Operations
i
dh
hae
Normal
Equalization
© To equalize the signal from the amplifier, set the Monitor Switch
[4]to the SOURCE position and the Equalizer Switch [3] to the
ON position.
@ To hear the unequalized signal from the amplifier, set the Monitor
Switch [4]to the SOURCE position and the Equalizer Switch
[3] to the OFF position.
@ To equalize the signal from the tape deck connected to the rear
Dubbing
panel tape terminals, set the Monitor Switch [4]to the TAPE
@ Tapes can be dubbed (copied) from the tape deck connected
[4] to the SOURCE position and the Equalizer Switch [B] to the
ON position.
@ To record the unequalized program source on the tape deck
connected to the rear panel tape terminals, set the Monitor
Switch [4] to the SOURCE position and the Equalizer Switch
[3] to the OFF position.
position and the Equalizer Switch [3] to the ON position.
To hear the unequalized signal from the tape deck connected
to the rear panel tape terminals, set the Monitor Switch [4] to
the TAPE position and the Equalizer Switch [3]to the OFF
position.
to the amplifier to the tape deck connected to the EQ-140. To
perform dubbing, put the original tape in the deck connected
to the amp and the blank tape in the deck connected to the
EQ-140. Set the Monitor Switch [4] to the SOURCE position.
Then set the amplifier to the: dubbing mode and start playback
of the first deck and recording of the second deck. If the amplifier
is equipped for dubbing in either direction, the original tape can
be put in the deck connected to the EQ-140 and the blank tape
in the other deck.
Recording
@ To record the equalized program source on the tape deck con-
nected to the rear panel tape terminals, set the Monitor Switch
Trouble shooting guide
DES
Sa
PT
a
EE
IS
®@ Move them farther apart.
Howling when the volume is turned up. | @ Turntable and speakers are too close
together.
© Low frequency level controls are set too |@ Lower level contro! settings until howling stops.
high.
Specifications
ea
a
a
OS
ED
Input:
Input sensitivity (FLAT):
150mV
AC outlet:
200 watts (UNSWITCHED)
Input impedance:
50 kohms
USA & Canadian models only
Output:
Output voltage (FLAT):
150mV
Power supply:
European models: AC220V, 50Hz
Output impedance:
1.0 kohms
Canadian models: AC120V, 60Hz
Max. input:
5 volts, 20Hz—20kHz, 0.05% THD
British & Australian models: AC240V, 50Hz
Frequency response:
10Hz to 35kHz (+0, —0.5dB)
Total harmonic distortion:
Less than 0.01% at 20Hz-20kHz.
Worldwide models: AC120V and 220V
1.5V output (FLAT)
Dimensions:
435(W) x 89(H) x 258(D) mm
Signal to noise ratio:
100 dB, 1.5V output, IHF-A input short.
17-1/8" x 3-1/2" x 10-1/8""
Adjustable range:
+12 dB
Weight:
2.4 kg, 5.3 ibs.
Gain:
0 dB
Specifications and features are subject to change without notice.
switchable, 50/60Hz
Publicidad
