Publicidad
Idiomas disponibles
Idiomas disponibles
Strobe Lights
Installation
Please read the entire manual carefully before beginning the installation.
Unscrew the strobe light lens to reach the mounting
screws and set aside (see Fig. 1).
Direct Mounting to a Flat Surface
1. Determine the location and, using the base as a
template, mark the holes for mounting and wiring.
2. Drill two
/
" (2.3mm) mounting holes.
1
16
3. Drill a wiring hole if wires will be concealed.
4. Connect the positive installation wire to the
positive terminal (red wire) and the negative
installation wire to the negative terminal (black
wire).
5. Mount to the surface using the long screws.
NOTE:
For more weather resistant installation,
apply a bead of silicone sealant around
the base before mounting.
6. Reattach lens and test.
Conduit Box / Conduit Drop Mounting
1. Install the conduit drop and/or conduit box
(optional, not included) according to their
instructions and thread the installation wires
through the conduit box/drop, adapter plate, and their gasket.
2. Thread the wiring through the wiring hole in the strobe base and attach the base to the conduit
box/drop using either pair of mounting holes in the base.
3. Connect the positive installation wire to the positive terminal (red wire) and the negative
installation wire to the negative terminal (black wire).
4. Fix in place with the original long screws.
5. Replace the lens and test.
4
Fig. 1
SECO-LARM U.S.A., Inc.
Conduit drop
(optional)
Conduit box
(optional)
Adapter plate (optional)
Threaded hole
Rubber gasket (optional)
Note gasket orientation
Strobe light base
Mounting screws
Strobe light lens
Publicidad
