Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Buzzer and Beep
• Once the unit is powered ON, press and hold Power Mode and
off the buzzer sound function.
•
• When the unit is turned ON or OFF, there will be a long beep sound.
• When a function button is used correctly, there will be a beep to indicate the selection is
activated.
• When a function button is used incorrectly or if the controls lock is enabled, there will be a
beep to indicate the selection is deactivated.
• When the unit detects a fault, there will be a warning beep for 4 seconds.
Error Codes
• If the machine detects a fault, the panel will display a fault code, as defined in the table
below.
Code
E1
Low Input-Voltage Error.
E2
Fan failure / Frequent start-stop.
E3
Compressor startup problems.
Compressor's running speed
E4
fails to reach the requirements.
E5
The model is overloading.
E6
(open circuit or short circuit)
Lid Closure
Slide the latch to the right to lock the lid or
to the left to unlock the lid.
49-1000674 Rev. 5
Description
NTC failure
Action
Check battery voltage and adjust Low Voltage
Contact customer service to arrange
further action.
Check air vents are clear.
Move fridge to cooler location
(ambient temperature may be too high).
button to turn on or turn
11
Publicidad
