VOX Amplification SMOOTH IMPACT Manual Del Usuario página 3

SMOOTH IMPACT
Part names and functions
1
IN (INPUT) jack: Connect the guitar cable here. This jack also functions as the power switch.
When you're not using this unit, unplug the cable from the input jack.
2
OUT (OUTPUT) jack: Connect this jack to a guitar amp, effect pedal or other device.
3
Effect switch: Press the effect switch to switch between the effect sound (the indicator is lit) and
the bypass sound (the indicator is unlit).
4
Display: This unit features an oscilloscope function, which shows the waveform's characteristics
as it passes through the Nutube circuit.
When the unit is in SELECT DISPLAY mode, you can also select other display modes or select
DISPLAY OFF mode.
How to enter SELECT DISPLAY mode: With the unit turned off, insert a plug into the INPUT jack
while holding down the effect switch to turn on the power. Once the indicator lights up, release
the effect switch. After "SELECT DISPLAY" appears in the display, the unit switches to SELECT
DISPLAY mode.
The display mode status is initialized if you keep holding down the effect switch without
releasing it. When "INITIALIZED!" appears, turn the power off and then back on again with-
out pressing anything.
Pressing the effect switch shows the next mode. If you want a selected mode to be automatically
used when you turn on the power, long-press the effect switch on the mode screen you want to
save. To make the unit use normal mode when turned on, turn the power off and then back on
again without pressing anything.
You can choose from three types of display modes.
DISP OFF: Turns the display off.
MODE1: Shows the amount of gain reduction.
MODE2: Shows the waveform as a series of bars.
- Part names and functions
2