Publicidad
Idiomas disponibles
Idiomas disponibles
Battery Replacement/Disposal
It is recommended that the unit be returned to manufacturer for battery replacement. Contact Customer
Service, toll-free, at 1-800-544-6986.
Battery Disposal
Contains a maintenance-free, sealed, non-spillable, lead acid battery, which must be
disposed of properly. Recycling is required — contact your local authority for
information. Failure to comply with local, state and federal regulations can result in fines
or imprisonment. For more information on recycling this battery, call toll-free (800) 822-8837.
WARNINGS
Do not dispose of this unit in fire as batteries inside this product may explode or leak.
Do not expose the unit containing a battery to fire or intense heat as it may explode.
Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting
(shorting can result in injury or fire).
ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer or authorized service
center. If you need assistance regarding accessories, please call: 1-800-544-6986.
WARNING: The use of any accessory not recommended for use with this tool could be hazardous.
TROUBLESHOOTING
Problem
The Battery Status Indicator LED
does not light when charging
Spotlight will not operate
Inflator/Compressor will not
operate.
LED Area Light will not operate
Solution
1. Check connection to the 120 Volt AC Charger or 12 Volt DC Charging
Port.
2. Check connection to AC or DC power source.
3. Confirm there is a functioning AC or DC current.
4. If using the 12 volt DC charging method, check the fuse in the 12 Volt
DC Charging Adapter. Replace, if necessary, following the directions on
page 6.
1. The battery may be completely discharged. Check Battery Status by
pressing the Battery Status Pushbutton located on the unit's front
panel. If necessary, charge the unit following the directions on page 5.
2. If you suspect the bulb is blown, check the filament. If the filament is
coiled and unbroken, the bulb is not blown. If the bulb is blown, refer
to the "Service Information" section of this Instruction Manual.
3. If the Spotlight does not operate after recharging as directed, refer to
the "Service Information" section of this Instruction Manual.
4. Turn all functions off and allow unit to cool. An internal thermal
protector may have opened.
5. The Main Fuse may need replacing. Refer to the "Service Information"
section of this Instruction Manual for information on obtaining a
replacement.
1. Turn all functions off and allow unit to cool. An internal thermal
protector may have opened.
2. The battery may be completely discharged. Check Battery Status by
pressing the Battery Status Pushbutton located on the unit's front
panel. If necessary, charge the unit following the directions on page 5.
3. The Main Fuse may need replacing. Refer to the "Service Information"
section of this Instruction Manual for information on obtaining a
replacement.
1. The battery may be completely discharged. Check Battery Status by
pressing the Battery Status Pushbutton located on the unit's front
panel. If necessary, charge the unit following the directions on page 5.
2. If the LED Area Light does not operate after recharging as directed, the
Main Fuse may need replacing. Refer to the "Service Information"
section of this Instruction Manual for information on obtaining a
replacement.
7
Publicidad
