Trotec BX50 MID Manual Del Usuario página 9

Technical information
Parameter
Model
Weight (packaging excluded)
Dimensions
(length x width x height)
Display
Power supply
Power consumption
Power loss
Measuring range
Basic current (lb)
Starting current
Accuracy class
Protection class
Indicator resolution
Operating conditions
Storage conditions
Measuring category
Pulse frequency (LED)
Type of protection
MID certification
Disposal
Always dispose of packing materials in an environmentally friendly manner
and in accordance with the applicable local disposal regulations.
The icon with the crossed-out waste bin on waste electrical or electronic
equipment is taken from Directive 2012/19/EU. It states that this device must
not be disposed of with the household waste at the end of its life. You will find
collection points for free return of waste electrical and electronic equipment in
your vicinity. The addresses can be obtained from your municipality or local
administration. You can also find out about other return options that apply for
many EU countries on the website https://hub.trotec.com/?id=45090.
Otherwise, please contact an official recycling centre for electronic and
electrical equipment authorised for your country.
The separate collection of waste electrical and electronic equipment aims to
enable the re-use, recycling and other forms of recovery of waste equipment
as well as to prevent negative effects for the environment and human health
caused by the disposal of hazardous substances potentially contained in the
equipment.
Only for United Kingdom
According to Waste Electrical and Electronic Equipment Regulations 2013
(SI 2013/3113) (as amended) devices that are no longer usable must be
collected separately and disposed of in an environmentally friendly manner.
EN
Value
BX50 MID
approx. 155 g
approx. 119 x 68 x 77 mm (with plug)
LCD with background illumination
230 V AC, single-phase, 50/60 Hz
10 VA
< 2 W
0.25 to 5 (16) A
5 A
0.004 lb
B
1 /
II /
0 to 999999.9 kWh
0 to 999999.9 W
-25 °C to 55 °C
0 % RH to 95 % RH (non-condensing)
-40 °C to 70 °C,
0 % RH to 95 % RH (non-condensing)
CAT II
1000 impulses/kWh
IP54
yes
Overview of the MID measuring devices used
Use the following table to manage the MID devices used.
No. Manufac-
turer
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Declaration of conformity
The device has a factory calibration which replaces the initial calibration by a
calibration authority. This is certified by a MID Declaration of Conformity
according to EU Directive 2014/32/EU. The validity of this declaration expires
8 years after placing on the market. Afterwards the user of the measuring
device is obliged to have the device recalibrated. The year of initial calibration
is indicated on the device after the CE mark. Example:
M24: The device was manufactured and first calibrated in 2024. If the device
is also placed on the market in 2024, the calibration validity ends at the end
of 2032. If the device is not placed on the market until 2025, the calibration
validity ends at the end of 2033.
0598: Number of the accredited calibration laboratory. Here: SGS
The following page shows the original declaration of conformity certifying
compliance with the relevant regulation.
BX50 MID / BX50 MID F / BX50 MID C
Type Year in which the
designation measuring device
has been designated
M24
Address of person
using the
measuring device
9