Descargar Imprimir esta página

Williams-Sonoma AMELIA Instrucciones De Ensamblaje página 9

Publicidad

Pottery Barn – Pottery Barn Teen – Pottery Barn Kids – Williams Sonoma Home – West Elm – Rejuvenation – Mark and Graham – GreenRow
22-Apr-2024
To Make the Wire Connections:
1.
Gently pull existing wire down from the ceiling junction box and allow wires to hang. The HOT or LIVE wire is usually black. The
NEUTRAL wire is usually white. Check to see if there is a ground wire that is usually green or green with a yellow stripe or
exposed copper metal wire. If needed, use a pair of wire strippers to remove about 1/2 inch of insulation from each wire.
Carefully inspect the fixtures wires. The NEUTRAL FIXTURE WIRE is WHITE. The HOT FIXTURE WIRE is BLACK and the
2.
BARE COPPER WIRE
confidence, then we recommend that you ask an electrician and that you not continue with the installation.
With the help of another person to hold the weight of the fixture, attach the fixture wires to the junction box wires as shown in the
3.
illustrations.
NOTE:
IT IS IMPERATIVE THAT THE JUNCTION BOX IN YOUR HOME BE PROPERLY GROUNDED!
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL BE COMPROMISED.
Check the wiring connections and if all looks good, gently tuck the wire connections neatly into the wall junction box.
Williams-Sonoma Inc.
is the GROUND WIRE. If you have any doubt and cannot identify the power-supply wires with
Connect the GROUND FIXTURE WIRE to
the GROUND J-BOX WIRE using the
Plastic Wire Nut Connector (H) and wrap
the connection with electrical tape. Be sure
that no wire strands are exposed.
If the
junction
box
DOES
GROUND WIRE, wrap the fixture's bare
ground wire around the Green Ground Screw
(G) and insert the screw into the Cross bar
(C) , marked as "GND", and tighten screw to
secure the wire.
Connect the NEUTRAL FIXTURE WIRE to the
NEUTRAL J-BOX WIRE first and then connect
the HOT FIXTURE WIRE to the HOT J-BOX
WIRE using the Plastic Wire Nut Connectors (H).
Wrap these connections with electrical tape. Be
sure that no wire strands are exposed.
Assembly Instructions
Instructions d'assemblage
Instrucciones de Ensamblaje
9/11
NOT have a
USA-A

Publicidad

loading