Publicidad
Idiomas disponibles
Idiomas disponibles
Remove
recovery
tank front panel By sliding
it straight
up.
Replace panel wilh converter.
Slide converter halfway down
opening until it is firmly in place,
SOLUTION
TUBE
Before connecting tube to cleaner,
make sure black tabs are extended
by pulling tan collar toward tube.
Open door on hood labeled "Stair/Upholstery Cleaning
Connection".
Press round solution tube connector onto round
projection inside door
Press connector collar down firmly to ensure that it is fully
connected.
When the solution tube is connected to the deep
cleaner, the nozzle brushes will automatically be
turned off and will not rotate when the deep cleaner is
turned on even if the speed selector is in the HI or LO
position.
Continued
._
TABS
The tank lid is replaced in a hinge-like manner. Position front
of lid under tabs on front of tank, Rotate lid down onto tank
Make sure lid is secure on all sides before cleaning:
For full suction,
it is important
that the recovery
tank lid is properly secured
before cleaning.
Reverse procedure to remove hose and solution tube.
Raise deep cleaner handle to upright position.
___t
/
NOZZLE
CONNECTOR
Attach
nozzle to connector
end of hose by sliding it onto connec-
tor until the tab locks it securely,
Using your thumb,
push forward
and up on the latch to remove
nozzle
Follow
the instructions
on pages
13 and 14 for the appropriate
cleaning
task.
12 Using stair/upholstery
nozzle
Publicidad
