Arctic King WWK05CM81N Manual Del Usuario página 19

Measure from the cabinet edge
H
H:About
H:About
INSIDE
H:About 1" to 1
OUTSIDE
Wooden Windows
Measure from the cabinet edge
H
H:About
INSIDE
H:About 1" to 1
OUTSIDE
Vinyl-Clad Windows
Fig. 6
window
frame
4. INSTALL SUPPORT BRACKET
Fig. 7A Fig. 7B
Fig. 8A
Page 18
2. While keeping a firm grip on the air
conditioner, carefully place the unit into
the window opening so the bottom of
" to "
5/8 3/4
the air conditioner frame is against the
for 5K)
window sill (Fig. 5). Carefully close the
to 1"
3/4"
window behind the top rail of the unit.
for 6K to 8K)
3
/
8"
for 10K to 12K)
NOTE
Check that air conditioner is tilted back
per dimension H (Fig. 5) (tilted about 3°
to 4° downward to the outside). After
proper installation, condensate should
not drain from the overflow drain hole
to 1"
3/4"
for 5K to 8K)
during normal use. Adjust the slope if
3
/
8"
otherwise.
for 10K to 12K)
Fig. 5
3. Extend the side panels out against the window
frame (Fig. 6).
A. Place the frame lock between the
frame extensions and the window
sill as shown (Fig. 7A for Wooden
windows), (Fig. 7B for Vinyl-Clad
windows).
Drive 3/4" (19 mm) or 1/2" (12.7 mm)
locking screws through the frame lock
and into the sill.
NOTE: To prevent window sill from
splitting, drill 1/8" (3 mm) pilot holes
before driving screws.
B1: For wooden windows:
Drive 1/2" (12.7 mm) locking screws through the
frame lock and into the sill (Fig. 8A).
NOTE: To prevent window sill from splitting, drill 1/8"
(3mm) pilot holes before driving screws. Drive 1/2"
(12.7mm) locking screws through frame holes into
window sash (Fig. 8B/8C).