Beta 3068 Instrucciones página 7

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
PERSONAL PROTECTIVE EQUIPMENT REQUIRED WHEN USING THE PALLET TRUCK
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS WEAR SAFETY FOOTWEAR WITH PROTECTIVE TOE CAPS
ALWAYS WEAR PROTECTIVE GLOVES
ALWAYS WEAR EYE PROTECTION
The above-mentioned personal protective equipment refers to the use of THE PALLET TRUCK in normal work
environments. If any hazardous situations are shown following specific surveys, it must be supplemented with
such equipment as described in the risk assessment document, in compliance with current standards concerning
safety in the workplace.
ASSEMBLING
• Fit the handle (b) (Figure 1) onto the pump body, inserting the drilled pin (a) (Figure 1). Fasten the pin (a) using the two clips
supplied
• Pass the chain (c) (Figure 2) of the handle (b) (Figure 2) through the central hole of the pin (a).
• Insert the end of the chain (c) (Figure 2) into the bracket housing (e) Figure 2) and fasten it with the nut at the end
• Lower the handle to the horizontal position and release the spring, removing the pin (f) (Figure 3).
Keep the pin. Use it to block the spring in the case of service work on the pump.
Figure 1
Figure 2
Figure 3
EN I
7