Descargar Imprimir esta página

Zealux INVERBOOST 075P Manual Del Usuario Y De Servicio página 55

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Connection to pilot the water pump
Notes
The factory supplies only the heat pump. All other components, including a bypass if necessary, must be provided by the
user or the installer.
Attention:
Please observe the following rules when installing the heat pump:
1. Any addition of chemicals must take place in the piping located downstream from the heat pump.
2. Install a bypass if the water flow from the swimming pool pump is more than 20% greater than the allowable
flow through the heat exchanger of the heat pump.
3. Install the heat pump above the water level of the swimming pool.
4. Always place the heat pump on a solid foundation and use the included rubber mounts to avoid vibration and
noise.
5. Always hold the heat pump upright. If the unit has been held at an angle, wait at least 24 hours before starting
the heat pump.
Filtration pump wiring (Dry contact)
1. Open the cover of the electric box
inside the machine
2. Connect the cables in the correct
terminal according to electric diagram.
53

Publicidad

loading