Publicidad
/_
//
/
/
/
PTOCable
6.
Figure23
Remove t he bow-tiecotterpin securing the deckstabilizerrodto the deck.
Slide the decklift rodfromthe mountingbracket o n the deckasshownin
Figure 24.
f
,,_ _
/,_ _
, ........................
,..
j
Figure 24
7.
Carefully remove the PTO cablefrom the rearofthe cuttingdeckby
removing the bow-tiecotterpinwhichsecures it. Remove t he spring from
the deckidlerbracket. S eeFigure 25.
8.
Gently slidethecuttingdeck(fromthe left side)out from underneath the
tractor.
Tires
Figure25
Neverexceedthe maximuminflationpressureshown on the sidewall of tire.
The recommended operating tire pressure is:
Approximately 10psiforthe reartires
Approximately 14psiforthe front tires
IMPORTANT:
Refer t o the tire sidewall f orexacttire manufacturer's
recommended o r maximum psi.Donotoverinflate.Uneven tire pressure could
cause the cuttingdeckto mow unevenly.
Battery
California Proposition 65WARNING! Batteryposts, t erminals, a ndrelated
accessories containleadandleadcompounds, chemicals k nownto the State of
California to cause cancer a ndreproductive harm.Wash hands after handling.
If removing the battery, disconnectthe NEGATIVE (Black)wire from its
terminal first, followed bythe POSITIVE ( Red)wire. When re-installing
the battery, alwaysconnectthe POSITIVE ( Red)wire to itsterminal first,
followed bythe NEGATIVE (Black)wire.
JumpStarting
Neverjumpstart adamagedor frozen battery. Becertain the vehicles do not
touch, andignitions are off. Donot allow cable clampsto touch.
1.
Connect positive(+) cableto positivepost(+) of yourtractor'sdischarged
battery.
2.
Connect the otherendofthe cableto the (positive+) postof thejumper
battery.
24
Publicidad
