Publicidad
21. This seat unit is not suitable for children under 6 months.
22. Do not fold the stroller and do not adjust the positions of the backrest while the child is in it!
23. ALWAYS engage the brake/parking device, while you do not hold the stroller or leave it even for a while.
24. When the pram body is installed on the stroller, please do not disengage the folding mechanism.
25. Do not use the stroller on stairs or the pavement. This may affect the strength of the construction and the
assembly.
26. The car seat does not replace a cot or a bed. Should your child need to sleep, then it should be placed in a
suitable pram body, cot or bed.
27. Only spare parts which are supplied or recommended by the manufacturer/distributor shall be used.
28. The assembly, folding and unfolding of the stroller must be performed by an adult only.
29. The bumper bar should always be attached to the frame of the stroller while the child is in the stroller! Do
not lift the stroller by its board, it is dangerous for the child!
30. Do not allow the child to stand up in the stroller, climb or hand from it!
31. Do not allow children to play with the stroller! It is dangerous for children or animals to play or run close to
the stroller or under it!
32. Do not use the stroller on stairs or escalators, because you may lose control of the product, the child might
fall and get hurt! You should pay extra attention while ascending or descending the pavement or a step.
33. WARNING! KEEP FROM FIRE. Do not use the product close to direct sources of heat – heating devices,
cookers or open fire.
34. Avoid using the product close to water bodies (pools, etc.)!
35. Do not use on uneven terrains, gravel surfaces or grassy areas (on meadows or lawns), muddy areas.
36. After unpacking of the product, remove all packing materials. They are not a toy, do not allow your
children to play with them.
37. The handle of the stroller is for guiding the direction, not for pushing and loading the stroller on
sidewalks and stairs.
PARTS
SEE FIGURE PD: 1.Canopy; 2.Safety board; 3.Shoulder pads; 4.Seat restraint button; 5.Seat; 6.Front wheels; 7.Rear
wheels; 8.Luggage and accessory basket; 9.Seat adjustment button; 10.Removal button for safety board; 11.Folding
button for chassis; 12.Handle; 13.Backrest adjustment button; 14.Front wheel orientation adjustment mechanism.
ASSEMBLY STEPS AND USE
1.UNFOLDING THE STROLLER – FIGURES 1-3: 1.Switch off the folding lock as it shown on Figure 1.; 2. Grab the handle and
pull upward to spread the stroller out.; 3. The stroller is fully unfolded when you hear the "click" sound.
2.INSTALLING AND REMOVING THE FRONT WHEELS – FIGURE 4: Insert the front wheel into the front frame hole, as
shown in Figure 4. Fix it until you hear a "click". Before usage pull the wheels down to check if they are securely installed.
To remove the front wheels, press the metal clip and the wheels are removed easily by pulling out.
3.ORIENTATION OF THE FRONT WHEELS – FIGURE 5: Press the lever downwards to activate the straight direction of front
wheels. Pull the lever upwards to activate the swiveling of front wheels.
4.INSTALLING AND REMOVING THE REAR WHEELS – FIGURES 6: Insert the rear wheel into the hole of the rear frame, as
shown in Figure 6. Fix until you hear a click. Before usage pull the wheels outward to check if they are securely installed.
To remove the rear wheels, push the button and the wheels are released quickly by pulling out.
5.USING THE BRAKE ON THE REAR FRAME– FIGURE 7:
To activate the parking device and lock the two rear wheels, press
down the pedal on the rear axle (Figure 7). To release the brake, pull up the pedal using your foot.
6. INSERTING THE CANOPY - FIGURE 8: Insert the canopy as shown in figure 8, then fasten the zipper.
7.MOUNTING THE SEAT/BASKET - FIGURES 9-10: Open the winter basket and place the handle in a vertical position. Align
the seat adapters with the slots on the frame. Install the seat. You should hear a click when the seat locks into place.
8.SEAT CONVERSION - FIGURES 11-12: On both sides of the back of the seat there is a strap system to change the position
of the stroller (from lying to sitting and vice versa). Buckle the straps under the seat to set the stroller to sitting mode.
Unbuckle the straps to switch to sleep mode.
9.CHANGING SEAT ANGLE - FIGURE 13: Press the strap system button on the back of the seat and move it up or down to
change the desired seat angle.
10.ATTACHING THE SAFETY BOARD – FIGURES 14: Insert both ends of the safety board into the two side holes of the
frame. Secure the guard until you hear a click. To remove the guard, press the release button on both sides of the frame
and pull at the same time.
17
Publicidad
