Publicidad
Idiomas disponibles
Idiomas disponibles
04 Initial Setup
When you turn on your TV for the first time, it immediately
starts the Initial Setup. Follow the instructions displayed on the
screen and configure the TV's basic settings to suit your viewing
environment.
• You will need a Samsung Account to access our network-
based smart services. If you choose not to log in, you will only
get a connection to terrestrial TV (applicable to devices with
tuners only) and external devices, e.g. via HDMI.
Using the TV Controller
You can turn on the TV with the TV Controller button at the
bottom of the TV, and then use the Control menu. The Control
menu appears when the TV Controller button is pressed while
the TV is On.
• The screen may dim if the protective film on the SAMSUNG
logo or the bottom of the TV is not removed. If protective film
is attached, remove the film.
Control menu
TV Controller button / Remote control sensor
05 Connecting the HDBase-T
HDBase-T connection of The Terrace is built-in for transmission of
audio and video data. It does not support transmission of power,
Ethernet and control signals including IR and RS232.
– Up to HDMI 1.4 is supported.
– CEC does not operate when the TV is Off.
General
• The appearance may differ depending on the product.
• Connecting parts may differ in different products.
• Data transmission is not available if HDBase-T (Rx) is
connected to HDBase-T (Tx) through a hub.
• While installing the product, be sure to use the cables and TX
devices certified by the HDBase-T Alliance.
• When connecting an external device via HDBase-T, for the
maximum resolution, use a certified TX device that supports
4K 30 Hz.
• This port (HDBT port on the TV) does not support ARC (eARC).
English - 12
Guidelines for connection
• HDBase-T (Tx) transmits data from an external device to
HDBase-T (Rx). Only 1:1 connection is available between
devices. Make sure to connect them via a LAN (CAT6 or higher
quality) cable.
• HDBase-T works with unshielded twisted pair (UTP) or
shielded twisted pair (STP) cables; but, to ensure CE
compliance, STP cables and STP Connectors are required. STP
cable and connectors are recommended to safeguard against
unpredictable environmental electrical noise which may
impact performance. It is recommended to use an STP cable
to maximize performance. Using a UTP cable or patch may
decrease performance.
• Before replacing the external device, first remove the HDBT
LAN (CAT6 or higher quality) cable.
• For HDBT signal stability, please use CAT6 or higher quality
cables are Certified by HDbaseT.
• Do not use CAT5E cables even though the cables are Certified
by HDbaseT.
Constraints
• When connecting an external device via HDBase-T, there may
be restrictions during communication between devices.
• When connection a gaming device via HDBase-T, the related
functions and screen resolution may not be supported
smoothly.
HDBase-T (Rx)
HDBT
HDBase-T (Tx)
LAN
HDMI IN
External Device
HDMI OUT
HDMI OUT
HDMI OUT
Publicidad
