Alarmcom ADC-VDB750 Manual De Instrucciones página 7

Physical installation (Slim Line I/II replacement)
Note: This optional procedure is optimized for easy replacement of Slim Line (I/II) models with an ADC-VDB750 using
the original Slim Line wallplate, eliminating the need to rewire.
The use of optional wedges is not supported with this method.
If wedges are required, the wallplate will need to be replaced, and the ADC-VDB750 Backplate Adapter accessory
should not be used.
1. Turn off power to the doorbell circuit (transformer). The recommended transformer rating is 16VAC, 10VA.
2. If the Slim Line Doorbell camera is wired to a mechanical chime, connect the Alarm.com International Video
Doorbell Power Module (sold separately as ADC-VDBA-PM-INT) to the mechanical chime using the instructions in
the "Physical Installation" section above.
Important: The Power Module should not be used with digital chimes.
3. Remove existing Slim Line Doorbell Camera from existing wallplate by loosening the bottom set screw.
4. Keep the wallplate installed, verifying that the wiring is connected well to the two screw terminals and ensuring that
the bottom set screw is loosened sufficiently to not be protruding at all above the threads at the bottom of the
wallplate.
5. Secure the ADC-VDB750 device to the ADC-VDB750 Backplate Adapter and secure at the bottom of the adapter
with the provided set screw.
https://answers.alarm.com/Partner/Installation_and_Troubleshooting/Video_Devices/Alarm.com_Video_Doorbell_(ADC-VDB7...
Updated: Wed, 07 Jun 2023 04:11:29 GMT
7