Alarmcom ADC-VDB750 Manual De Instrucciones página 9

Idiomas disponibles

Connect the ADC-VDB750 to the network

AP Mode (recommended)

1. Verify that device boots (flashing red LED) to AP mode (flashing white LED). If the LED is not white after two

minutes, hold down the doorbell button and release when the LED begins to blink white (about 35 seconds).

2. On an Internet-enabled device, connect to the Wi-Fi network ADC-VDB750 (XX:XX:XX) where XX:XX:XX is the

last six characters of the ADC-VDB750's MAC address, which is located on the device or on the packaging.

3. On the same device, open a web browser and enter

Follow the on-screen instructions to add the ADC-VDB750 to the Wi-Fi network. The LED may briefly turn red

before blinking green. The LED will be solid green when the connection is complete.

4. Add the device to the account by either selecting the account in the MobileTech app or by using a web browser

and entering the following URL:

password).

5. Select the device from the video device list or enter its MAC address to begin adding. The MAC address is located

on the device or on the packaging.

6. Follow the on-screen instructions to finish adding the device.

WPS Mode

1. Verify that device boots (flashing red LED) to AP mode (flashing white LED). Hold down the doorbell button and

release when the LED begins to blink blue (about 30 seconds).

2. Activate WPS mode on the router. The device will begin to connect to the Wi-Fi network. The LED will be solid

green when the connection is complete.

3. Add the device to the account by either selecting the account in the MobileTech app or by using a web browser

and entering the following URL:

password).

4. Select the device from the video device list or enter its MAC address to begin adding. The MAC address is located

on the device or on the packaging.

5. Follow the on-screen instructions to finish adding the device.

Customer - Customer app installation wizard

1. Log into the Customer app. You will need the username and password of the account to log in.

2. Tap Add Device. If you do not see the Add Device option, please use the instructions above to complete your

installation.

3. Tap Doorbell Camera.

4. Tap ADC-VDB750.

5. Follow the on-screen instructions.

https://answers.alarm.com/Partner/Installation_and_Troubleshooting/Video_Devices/Alarm.com_Video_Doorbell_(ADC-VDB7...

http://vdb750install.com

www.alarm.com/addcamera

or 192.168.1.1 in the URL field.

(you will need the customer user name and

Updated: Wed, 07 Jun 2023 04:11:29 GMT