Descargar Imprimir esta página

RS Pro RS MP-1 Manual De Instrucciones página 3

Detector de campo magnético

Publicidad

Magnetic Field Detector/English
4. OPERATING INSTRUCTIONS
Use your test magnet and move it to the probe, this will then light. If the test lamp does
not light - change the batteries.
1) First check the batteries according to the "functions check" instructions
2) Touch the test object with the Magnet Tester probe.
If the lamp lights, the object is electrically actived.
3) It is not necessary to unscrew the test object from its mounting on the equipment in
order to carry out the test – a magnetic coil can be tested through its protection cover.
4) It is not necessary to stop the machinery or the equipment in order to carry out the
test.
5) Sometimes stray magnetic fields from other nearby equipment may cause the test
lamp to blink momentarily. When close to an activated magnetic coil, the test lamp will
give a fixed light.
6) Press and hold the black test button, placing the tip of the unit near a magnet field
produces a steady red glow at the tip.
7) Press and hold the back black button to turn the flashlight on, Press the black button
again, the flash light will be turned off.
5. BATTERY REPLACEMENT
When the battery voltage drops below 2 volts VoltBeat provides a visual indication by
stopping the VoltBeat flash.
Replace with 2 AAA batteries. Slide the battery cover ( ③ /Fig)and remove the battery.
Make sure the battery cover is secure after changing the battery.
NOTE: If not used reguarly please remove battery.
2
Manuel d'instructions
RS MP-1
No d'inventaire: 136-5674
Détecteur de champ magnétique
FR

Publicidad

loading