S+ARCK Parrot ZIKMU Guía De Instalación Rápida página 118

As part of our ongoing concern to upgrade and
improve our products, the product that you have
purchased may differ slightly from the model
described in this guide.
If so, a later version of this guide might be
available in electronic format at Parrot's website
at www.parrot.com.
Declaration of Conformity
We, Parrot S.A. of 174 quai de Jemmapes,
75010 Paris, France,
sole responsibility
Parrot by Starck speakers to which this
declaration relates are in conformity with
appropriate standards EN300328, EN300220,
EN301489-17, IEC60065 following the provision
of Radio Equipment and Telecommunication
Equipment directive, with requirements covering
EMC directive 89/336/EEC and Low Voltage
directive 73/23/EEC.
Identification N. 394 149 496 R.C.S. PARIS
Parrot
FCC Compliance Statement
This device complies with part 15 of the FCC
rules. Operation is subject to the following two
conditions:
(1). this device may not cause harmful
interference, and
(2). this device must accept any interference
received, including interference that may cause
undesired operation.
Note: The manufacturer is not responsible
for any radio or tv interference caused by
118
declare under our
that our product, the
S.A.
unauthorized modifications to this equipment.
Such modifications could void the user's
authority to operate the equipment.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV
technician for help.