Makita DHR241 Manual De Instrucciones página 6

Reversing switch action
A
► 1 . Reversing switch lever
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
CAUTION:
• Always check the direction of rotation before
operation.
• Use the reversing switch only after the tool
comes to a complete stop. Changing the direc-
tion of rotation before the tool stops may dam-
age the tool.
• When not operating the tool, always set the
reversing switch lever to the neutral position.
Selecting the action mode
Rotation with hammering
1
3
► 1 . Lock button 2. Rotation with hammering 3. Action
mode changing knob
For drilling in concrete, masonry, etc., depress the lock
button and rotate the action mode changing knob to
the symbol. Use a tungsten-carbide tipped bit.
1
2
Rotation only
B
► 1 . Rotation only
For drilling in wood, metal or plastic materials, depress
the lock button and rotate the action mode changing
knob to the
Hammering only
► 1 . Hammering only
For chipping, scaling or demolition operations, depress
the lock button and rotate the action mode changing
knob to the
scaling chisel, etc.
CAUTION:
• Do not rotate the action mode changing knob
when the tool is running. The tool will be
damaged.
• To avoid rapid wear on the mode change mech-
anism, be sure that the action mode changing
knob is always positively located in one of the
three action mode positions.
6 ENGLISH
1
symbol. Use a twist drill bit or wood bit.
1
symbol. Use a bull point, cold chisel,