Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
Tool Use Hazards.
• Use this tool for the manufacturers intended purpose only. Use other than that described in this manual
can result in injury or property damage.
• Inspect all aspects of the electrical box to ensure safety.
• Only qualified personnel should use knockout equipment.
• Keep all decals clean and legible, and replace when necessary.
FAILURE TO OBSERVE THESE WARNINGS CAN RESULT IN SEVERE INJURY OR DEATH.
:
Read and understand all of the instructions and safety information in this manual before
CAUTION
operating or servicing this tool.
FAILURE TO OBSERVE THESE CAUTIONS CAN RESULT IN INJURY OR PROPERTY DAMAGE.
:
CAUTION
Make sure bystanders are clear of the work area when performing knockouts. Nearby personnel can be
injured if there is flying debris.
• Do not use if the dies are damaged as this can cause binding leading to tool malfunction.
• If tool is in disrepair, DO NOT USE. Have tool serviced at an AUTHORIZED SOUTHWIRE
REPAIR CENTER
FAILURE TO OBSERVE THESE CAUTIONS CAN RESULT IN INJURY OR PROPERTY DAMAGE.
PURPOSE OF THIS MANUAL
This manual is intended to familiarize all personnel with the safe operation and maintenance procedures for
the following Southwire Tools and Equipment: MAX PUNCH™ 360 HYDRAULIC PUNCH. Keep this manual
available to all personnel. Replacement manuals are available upon request at no charge at
www.southwire.com.
DESCRIPTION OF OPERATION
The MAX PUNCH™ 360 Hydraulic Punch is a tool that will knockout ½" – 4" diameter holes in mild steel
and stainless steel electrical panels.
SOUTHWIRE.COM | 5
Publicidad
