Publicidad
Idiomas disponibles
Idiomas disponibles
. Starting up the soundbar
.. Connecting the soundbar and subwoofer to the
power supply
Connect the supplied mains cable to the AC~IN
soundbar and plug the other end into an easily accessible power socket.
The standby LED lights up.
Connect the second supplied mains cable to the AC~
woofer and plug the other end into an easily accessible power socket.
The pairing LED on the back of the subwoofer lights up.
.. Switching on the soundbar/switching to standby
mode
Switch on the soundbar by pressing the
or the soundbar
During operation, press the
trol to switch the soundbar into standby mode.
.. Connecting the soundbar and subwoofer
The soundbar and subwoofer connect automatically the first time they are used.
Once the connection is successful, the pairing LED on the back of the subwoofer
lights up continuously.
If the pairing LED is flashing, the automatic connection has failed. To connect the
devices manually, proceed as follows:
Turn on the soundbar.
Press and hold the PAIR button
ing LED flashes rapidly.
Press and hold the SOURCE button
The connection process then starts automatically. The operating LED
soundbar flashes green and the pairing LED
as soon as the connection between the soundbar and the subwoofer has been suc-
cessfully established.
If a television or other audio output device is connected via the AUX or
HDMI port, the soundbar switches on automatically after a few seconds
if the television or audio output device is switched on.
If you disconnect from the TV or audio output device, or if the volume
on the TV or audio output device is too low, the soundbar automatically
turns off after about 15 minutes.
.
4
button on the soundbar or on the remote con-
on the back of the subwoofer until the pair-
19
connection socket on the
12
16
button on the remote control
on the soundbar.
5
on the subwoofer is constantly lit
17
socket on the sub-
35
on the
3
DE
FR
NL
ES
IT
EN
189
Publicidad
