Descargar Imprimir esta página

Toshiba Carrier RBC-AXU33CP-UL Manual De Funcionamiento página 12

Publicidad

Idiomas disponibles

Idiomas disponibles

6
Operating unit with timer
ON timer and OFF timer
COMFORT
SLEEP
Setting TIMER
1
Push ON / OFF TIMER button (
during operation.
Press the ON or OFF TIMER buttons as required.
The previous timer setting is displayed and
flashes along with ON/OFF timer display.
Set the timer to the desired time.
Each press of the TIMER button changes the time
in ten minute steps. Pressing the TIMER button
continually changes the time in one hour step.
2
SET
button
Press the SET
The timer time is indicated and the timer starts.
Cancelling TIMER
3
CLR
button
Press the CLR
setting.
11-EN
SWING
FAN
FIX
QUIET
Hi POWER
or
button to set the timer.
button to cancel the timer
CAUTION
When you select the timer operation, the remote
controller automatically transmits the timer signal
to the indoor unit at the specified time. Therefore,
keep the remote controller in a location where it
can transmit the signal to the indoor unit properly.
Otherwise, the time lag of up to 15 minutes will
occur.
If you do not press the SET
30 seconds after setting the time, the setting
will be cancelled.
Once you select the timer operation mode, the settings
are saved in the remote controller.
Thereafter, the air conditioner will start operating under
the same conditions when you simply press the
ON/OFF button of the remote controller.
If the clock display is flashing, you cannot set the timer.
)
Follow the instructions in the section "Setting the
clock" and then set the timer.
Combined timer (Setting both ON and
OFF timers simultaneously)
OFF timer —> ON timer
(Operation —> Stop —> Operation)
This feature is useful when you want to stop the
air conditioner after you go to sleep, and start it again
in the morning when you wake up or you return home.
Example:
To stop the air conditioner and start it again next
morning.
Operation
Setting combined TIMER
1
Press the OFF TIMER
the OFF timer.
2
Press the ON TIMER
the ON timer.
3
Press the SET
– 11 –
button within
Operation again
Stop
button to adjust
button to adjust
button.

Publicidad

loading