Publicidad
Idiomas disponibles
Idiomas disponibles
7
Adjusting louver direction
Never move the louver (air direction up / down adjusting plate) which is operated on the remote controller with
●
hands except a case of cleaning the louver.
While the air conditioner is not working, the louver (air direction adjusting plate) is closed automatically.
●
The louver angle does not change immediately after the FIX button is pushed. Check the louver status, and push
●
FIX button after a while.
To set louver direction
Push
button during operation. Louver direction
FIX
changes each time you push the button.
To start swinging
Push
button on the remote controller. Louver
SWING
swinging appears on the display and louver direction
automatically changes up and down.
Cooling / dry mode
Keep the louver pointed upward. Otherwise, dew drop
may form around the discharge port and drop from
the unit.
8
Mounting remote controller holder
Direct the transmitter of the remote controller
●
toward the signal receiving unit.
When the signal is normally received, "Pi" sound
is heard once.
("Pi, pi" sounds are heard only when the operation
has started.)
The standard distance for signal reception is
●
approximately 8 m vertically against the signal
receiving unit.
The distance differs a little according to the
capacity of the battery or other factor.
Be careful there is not something to block the
●
signal between the signal receiving unit and the
remote controller.
Do not put the remote controller on the place
●
exposed to the direct sunlight or air from the
air conditioner or near the stove, etc.
Do not drop, throw, or clean with water the remote
●
controller.
The signal may not be accepted in a room where
●
the electronic instantaneous-ON type or inverter
type fluorescent light is set. For details, contact the
shop which you purchased the air conditioner.
13-EN
To stop swinging
Push
button once again while the louver is swinging.
SWING
The louver can be stopped at a desired position.
CAUTION
The louver angle does not change if the FIX button
●
is pushed during SWING operation. Stop the SWING
operation before changing the louver angle.
Do not operate the air conditioner for long hours
●
with the airflow direction set downward during the
cooling or dry operation.
Otherwise, condensation may occur on the surface
of the vertical airflow louver and cause dew dripping.
■
To use the remote controller
setting to wall
Before you actually install the remote controller
●
holder on a wall or pillar, check whether the remote
controller signals can be received by the indoor unit.
Flat head
wood screw
Mounting and removing the remote
controller
To mount the remote controller hold it parallel to
●
the remote controller holder and push it in fully.
To remove the remote controller slide the remote
controller upwards and out from the holder.
– 13 –
Remote control holder
Publicidad
