Publicidad
Idiomas disponibles
Idiomas disponibles
Over temperature protection
Low temperature protection
Lightning protection
Installation Steps
Positioning holes according to the
size of the wall-mounted backplane,
then punching holes of 4-φ6*35mm
and inserting expansion tubes.
Lock the 4-M4*32 self-tapping
screws into the expansion tube, and
f ix the wall-mounted backboard on
the wall.
Open the upper cover of the
charging pile, hang the pile on the
wall-mounted backboard, and lock
the screws from the bottom of the
pile.
Pass the power cable of 3*6mm
through the corresponding water-
proof head and connect it to the
corresponding input terminal.
Lock the screws of the upper cover
panel.
Inspection & Debugging
Pre-operation inspection
The installation location of the AC
pile should be convenient to operate
and maintain.
Make sure the power cable of the
AC pile is properly connected and
securely installed.
Make sure that the selection of
leakage protection switch at the AC
inlet is appropriate.
Power on the equipment
Close the leakage protection circuit
breaker of the power supply line.
After the AC pile is powered on, there
will be a power-on self-check for
about a few seconds, and the
indicator light alternately displays
red, yellow and green for 1S.
Normal standby: the green light is
always on.
Equipment failure：the red light stays
on.
The Operation of Charging
Insert the EV charger (connect the
charging plug).
Start charging (Method 1: Plug the
charger and start charging; Method
2: Use the designated charging card
to swipe. The green light flashes
indicating normal charging.) Swipe
the card again to end charging.
Method 1: Pull out the charger to end
the charging; Method 2: Swipe the
card again to end the charging.
Put the EV charger back to its place.
Precautions
For the f irst installation, attention
should be paid to the power cable
according to IN-L (fire), IN-N (zero),
PE (ground) one by one, and the fire
wire and zero wire cannot be
reversed.
3
EN
Publicidad
