Descargar Imprimir esta página

Parkside PKH 3000 B1 Instrucciones De Utilización Y De Seguridad página 28

Ventilador de aire caliente de cerámica

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 110
To turn on the product, turn the heating level
 
switch 
clockwise .
4 ]
[
Position Meaning
0
Product turned off
Fan operation
no heating power
Low heating level
1700 W
High heating level
3000 W
NOTES:
Heating level switch
 
Control light 
  on .
2 ]
[
Heating level switch
 
Control light 
off .
[
2 ]
˜ Setting the temperature
To regulate the temperature at high or low
 
heating level, turn the temperature control 
clockwise until it stops .
As soon as the desired temperature has been
 
reached, turn the temperature control 
counter-clockwise until you hear a clicking
sound .
NOTE: The integrated thermostat
automatically turns the heating function on and
off to keep the temperature at a constant level .
Position Meaning
lowest temperature range
low to medium temperature
range
medium to high temperature
range
highest temperature range
set to
,
or
4 ]
[
set to 0:
4 ]
[
3 ]
[
3 ]
[
˜ Adjusting the radiation angle
Changing the radiation angle of the air
 
outlet
: Use the knurled screw
[
5 ]
housing to the desired angle .
NOTE: Do not touch the product with wet
hands or if the product's housing is hot .
˜ Turning off
NOTE: If you have used the product at high
or low heating power, let the product run in fan
mode for about 30 seconds . This will prevent
heat build-up in the housing .
Set the temperature control 
 
:
heating level switch 
Disconnect the power plug 
 
outlet .
˜ Overheating protection
The product is equipped with overheating
 
protection . If the product overheats, the
heating element will turn off automatically .
However, the fan continues to run so that rapid
cooling is achieved . The product will turn on
again automatically once it has cooled down
properly .
m
WARNING! There is usually a reason for
overheating! It can indicate a fire hazard!
Check whether the product is giving off
 
sufficient heat:
Is the product covered or is it too close to a
wall or other obstruction?
Is the grid blocked in the front or at the
back?
Is the fan blocked?
Rectify the problem if possible, or contact the
 
service hotline (see the section "Service") .
to turn the
[
6 ]
to
and the
[
3 ]
to 0 .
4 ]
[
from the socket-
7 ]
[
GB/IE
29

Publicidad

loading

Este manual también es adecuado para:

365185 2101Hg07991